helico55
About
- Username
- helico55
- Joined
- Visits
- 463
- Last Active
- Roles
- Member
Comments
-
I just try again with full landing conf and it s ok. thank you. question from how many NM of IKDEB i must to begin get down flaps and gear down ?
-
Geforce experience
-
Is it possible for you to do a video how you do ?
-
No I did VTO to PIKVO
-
look here no problem.same approach
-
-
Problem begins at Ulbom just after pitch hold
-
I observed I have only issue with this rnav approach. I did many other rnav approach and no issue. Yesterday I tried and no problem.this morning i tried again and pith hold.
-
again pitch hold.Now my VNAV was ok.
-
-
Why if I select vto on the picture vnav not working ? I must to descent 2300 feet min . I must use VS. I engage vnav and not descent.
-
Ok thank you it's ok now. Was vnav activate too early. I observed TOD on the ND just before Ulbom . I did fly second time and TOD not appear but descent perfect. Is it supposed TOD appear each time ? Second question about rudder trim.…
-
can you check my last video ? always same issue .PITCH HOLD after each waypoint of RNAV descent. CYQB RUNWAY 24
-
-
Ok super thanks you so much
-
2 things i don t understand : 1:not set the RNP to 0.30, a DH (based on the radar altimeter) is only selected for ILS CAT II / III, here the DA would be 557 (based on barometric altitude) has been correct. The approach is based on a VDA of 3.10 °…
-
can you look my video and say me my mistakes and why i get pitch hold. CYUL to CYQB star pesac4 runway RNAV 24
-
Perhaps i don't understand but I just did a fly and arm app don't arm itself even if I'm near of the airport. But perhaps if I use VTO to set vnav for next constraint altitude when there is a next waypoint with no constraint altitude. …
-
From what distance of the airport i must to arm approach ?
-
Hi. If don't arm approach,is arm approach will be activate it's self ? If i must to arm approach when must i arm approach and how far of the destination airport ? Because i arm approach when arm app appear in nav page of fms about 50 nm of th…
-
So when I prepare my flight I must to take a flight routing by simbrief and only enter runway departure SID and STAR that's it ? After I wait ATC give me runway landing ? Surely there will be mistake with last part of flight if…
-
But when i prepare my flight must i delete waypoint after FIDEK of the star ?
-
Ok super thank you so much
-
can you help me about this approach for runway 27 with this star ? after AGEBE direct to KAYDE ? or i must to take TYOTA and delete FIDEK BAMGE AND AGEBE ? I don t understand ?
-
-
-
Ok super thanks
-
Ok sorry. I looked IGVIN and ODKUD.
-
-
Yes up to date. Flight plan from simbrief and airac cycle up to date.