kroswynd
About
- Username
- kroswynd
- Joined
- Visits
- 6,379
- Last Active
- Roles
- Member, Administrator, Moderator
- Invited by
- Boss
Comments
-
Thanks for the share but your re-install procedure is a bit intense for the average user, and several of the steps that you post are not necessary. The simplified method: * Back up your aircraft.cfg & mjc84.ini (mainly for any changes t…
-
By default no. The aircraft we modeled worked in this manner and that is how it was modeled. Cheers
-
Have you been able to locate the file in question?
-
Are you saying that you do not have any patches available in your User profile from the USER AREA, or you have not yet made the attempt to download any of the available patches? Cheers
-
Have you applied the update/patches available in the USEA AREA here at the Majestic Software website? If not, then kindly apply them and keep us posted of your results. Cheers
-
Ken, Good to know that you are able to get the issue sorted out. I thought that you had already attempted a re-installation.
-
Kindly refer to your "docs" folder where the Control Panel Guide will provide the required information.
-
All of mine do....yes
-
Thanks for the info...as I just did a similar test, but all of my liveries played the boarding music.
-
I will run a test on this theory tomorrow.
-
Unless there may have been some form of corruption with your scripts. When looking at your mjc84.ini are your settings configured the way that you want them to be? i.e: here is an example whereby you can see that the entertainment_music_enabled…
-
http://majesticsoftware.com/forums/discussion/5/accessing-the-old-mjc8q400-forum-in-the-read-only-mode
-
The engines must be off the the doors open (if I recall)...so that the boarding process may be simulated. Also ensure that you did not disable this option via the mjc84.ini under the SOUND section.
-
Have you assigned the use of the SPOILER function in the CPAN as well, this is pertinent so that the software can determine which input device you wish to use. Ensure that the Q400 is running, open the CPAN and assign the appropriate tiller settin…
-
Write us an email to our Support department with an explanation regarding the need to have your installations re-activated. Be sure to include all credentials used when purchasing the Q400...i.e. a. Full Name b. Email address used c. Vendor …
-
@Asid, The feature that you speak of is a custom feature that we implemented and is not one controlled via the SIM platform. If it is correctable we'll be be sure to have a look into addressing the issue. If it is not we will leave it unaddress…
-
Thanks for the update, hope that you are able to get the issue resolved. Keep us posted Cheers
-
Thanks for the share....good fabrication
-
Sounds good.....regarding the assignment issue, so we now need to get your flight control issue fixed
-
Do not forget to "UN_PAUSE" the simulator after sending your data from the Control Panel to the simulator
-
Trying to cross-compare P3D's flight control functionality with the Q400's 125Hz control system will not work well ...its one or the other. When you say you do not see the ELEVATORS, are referring to physically on the aircraft or via the PFCS ind…
-
With the USB change for one of your devices it sounds like the input device assignments no longer coincide with the original configuration. You may want to look at the input device numbers and adjust accordingly.
-
Slow .....BUT Steady goes the train
-
For this to be done "the correct way" there are many variables that go into factoring landing distance apart from length of the runway.....(weight, temp, runway condition, altitude, wind component). Now its not that fact the implementation of perfo…
-
While this data can be helpful, it is not likely to happen as this is not the norm for every operator.....most data is usually acquired from the dispatch release. Which to be done correctly would require data for all available runways